Setting a command in OnSetSlave event is not saved
- Havenstad FM
- Posts: 104
- Joined: 23 Apr 2016 12:36
Setting a command in OnSetSlave event is not saved
Hi Bernd,
I tried the following on our 2 licensed copies -and- on a demo copy of PFOA and it fails every time.
Can you please look in to this....
With kind regards,
Jack Reitsema
ITC Havenstad.FM
I tried the following on our 2 licensed copies -and- on a demo copy of PFOA and it fails every time.
- Open Settings (F3)
- Goto category Events/Commands
- Expand Application
- Enter a command in the OnSetMaster event, i used SHOW_ALERT_WINDOW I am the MASTER on pc ${machinename}
- Enter a command in the OnSetSlave event, i used SHOW_ALERT_WINDOW I am the SLAVE on pc ${machinename}
- Close Settings
- Close PFOA
- Start PFOA again with commandline parameter -master
- Notice everything works as expected - the messagewindow is shown
- Close PFOA and start it again, but this time use commandline parameter -slave
- Notice that the message window is NOT shown
- Open Settings again and look at OnSetSlave event setup - The command has not been saved
- Go to windows explorer and open the file 'ProppFrexx ONAIR.config'
- Scroll down to <configuration><ProppFrexx><EVENT> and notice that key="OnOnSetSlave" still has the value set
Can you please look in to this....
With kind regards,
Jack Reitsema
ITC Havenstad.FM
Re: Setting a command in OnSetSlave event is not saved
Yes, that's indeed a bug and will be fixed in the next version.
Bernd - radio42
ProppFrexx ONAIR - The Playout and Broadcast Automation Solution
ProppFrexx ONAIR - The Playout and Broadcast Automation Solution
Re: Setting a command in OnSetSlave event is not saved
Fixed in the latest v4.0.1.27 - update.
Bernd - radio42
ProppFrexx ONAIR - The Playout and Broadcast Automation Solution
ProppFrexx ONAIR - The Playout and Broadcast Automation Solution