Silence detection and stereo loss
Posted: 18 Oct 2019 09:33
Hi,
We juste noticed an unexpected behavior of the Silence detection function..
The OnSilence() was triggered by a temporary loss of one side of our stereo output (see the waveform).
As this sort of cable-diyng shortcircuits can happen few seconds before someone notice this, is it possible to configure the silence detection to avoid that sort of false detections ?
Solution could be to analyse signal as a full stereo instead of two independant mono channels or as a mono downmix.
Best regards,
Fred
We juste noticed an unexpected behavior of the Silence detection function..
The OnSilence() was triggered by a temporary loss of one side of our stereo output (see the waveform).
As this sort of cable-diyng shortcircuits can happen few seconds before someone notice this, is it possible to configure the silence detection to avoid that sort of false detections ?
Solution could be to analyse signal as a full stereo instead of two independant mono channels or as a mono downmix.
Best regards,
Fred