Re: when loading cardwall light up knobs on D&R Airence mixer
Posted: 29 Dec 2022 15:11
You can use the control-command EXEC_SEND_DRAIRENCE_SETLED to set the light of a knob of the Airence. See the D&R manual for more details.
E.g. you can use the lednr 255 to set this for all LEDs.
You can trigger this with the OnCartwallChanged event, which is raised when the cardwall is loading (there is no event, when this finishes, as this is anyhow happening asynchronous).
E.g. the following commands might do what you are looking for:
E.g. you can use the lednr 255 to set this for all LEDs.
You can trigger this with the OnCartwallChanged event, which is raised when the cardwall is loading (there is no event, when this finishes, as this is anyhow happening asynchronous).
E.g. the following commands might do what you are looking for:
Code: Select all
ASYNC
EXEC_SEND_DRAIRENCE_SETLED 255|3
SLEEP 1000
EXEC_SEND_DRAIRENCE_SETLED 255|0